Jump to content
Ultimate Subaru Message Board

presure plate problems on brumby


Recommended Posts

Hi there needing some help I have just installed an ea82 in my brumby 4 speed gearbox and my clutch leaver is floppy, did I put the clutch plate in the wrong way or what. The original pressure plate and clutch plate are in and were Im at is what pushes the thrust bearing against the pressure plate. Please help I have had motor out three time so fare.

Link to comment
Share on other sites

If the clutch was on wrong you would not have been able to mate up the PP to the flywheel.

Are the spring clips still attached to the lever and throwout bearing?

Sometimes they will come loose during install.

You may also need to adjust the cable nut so it has tension.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...