Jump to content
Ultimate Subaru Message Board
sikend667

EJ22T swap issues

Recommended Posts

 I can do a mobile service and come up and get it running if you want.  If you're getting CEL, power from the relay, you are really close.  Don't give up yet.

 

ALOT cheaper than an aftermarket ECU.  Plus your gonna have to wire up and program the aftermarket ECU anyhow.

Share this post


Link to post
Share on other sites

welll regrounding did absolutely nothing lol

 

What it sounds like is happening:

 

ECU must not be powered properly.

 

Your next step:

 

Pull up an ECU pinout for your ECU, and triple check that you have good power and ground to all the wires that need it.

Share this post


Link to post
Share on other sites

ok ill go thru and probe everything this weekend see if i missed somthing 

 

thank you again guys for the help so far and gloyale if i wasnt broke and it wasnt a 4 hour drive id take u up on that lol

Edited by sikend667

Share this post


Link to post
Share on other sites

ok ill go thru and probe everything this weekend see if i missed somthing 

 

thank you again guys for the help so far and gloyale if i wasnt broke and it wasnt a 4 hour drive id take u up on that lol

 

Corvallis is barely 2 maybe 2-1/2 hours.

Share this post


Link to post
Share on other sites

ok so i did it finally got pissed off enough and bought an aftermarket ECU....... will be wiring it up this weekend and pitching the factory computer in the pile of subaru crap for testing lol

Share this post


Link to post
Share on other sites

I almost guarantee you cut out the Diode, and inherently the power wire to the ECU.... 

I've done this before, and now know to keep that little section. Nobody really tells you about it in Swap Explanations though. 

Share this post


Link to post
Share on other sites

I almost guarantee you cut out the Diode, and inherently the power wire to the ECU.... 

 

I've done this before, and now know to keep that little section. Nobody really tells you about it in Swap Explanations though. 

+1

Share this post


Link to post
Share on other sites

I almost guarantee you cut out the Diode, and inherently the power wire to the ECU.... 

 

I've done this before, and now know to keep that little section. Nobody really tells you about it in Swap Explanations though

 

Perhaps "somebody" should to avoid this problem for others?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×