Jump to content
Ultimate Subaru Message Board

Recommended Posts

I am looking for the pin out of the above connector. It is from my 1996 subaru legacy. The abs system is the 5.3 unit from bosch. This connector plugs into the Nippon abs module. I have found info on the abs module in the service manaul but it is different from this connector. 

 

Any help appreciated

 

cheers

Nick

post-33072-0-56573100-1371897207_thumb.jpg

Share this post


Link to post
Share on other sites

I have the 96 FSM but can't post the page.

Its in the Troubleshooting section under brakes, ABS 5.3 type.

Section 4-4C, subsection 5, page 7, Control Module I/O Signal. Hopefully that makes it easier to find.

Share this post


Link to post
Share on other sites

Thanks for the help I managed to find it where you said it would be. So much easier to fault find now I have the pin outs.

 

Cheers

Nick

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×