Jump to content
Ultimate Subaru Message Board

Recommended Posts

As Fairtax suggested, check your owner's manual. A brandy new 2014?? At the very least, ask the salesman to modify this as a courtesy. If you find the particular sequence for your car, please post it here. Welcome to the board.

I know your model isn't listed at the below link but it has to be one such "simple" fix. Do they really have to make it so complicated?!?

http://www.cars101.com/subaru/keyless.html#08chirp

2009, 2008 Outback Legacy, Tribeca, Impreza

Audible Chirp when locking/unlocking
give you an audible signal when the doors lock and unlock. If desired,
you may turn the audible signal off.

Do the following to deactivate the audible
signal. You can also use the same steps to restore the function.

1. Sit in the driver’s seat and shut all
doors and the rear gate.

2. Hold down the UNLOCK side of the power
door locking switch.

3. While holding down the “UNLOCK” side
of the power door locking switch, pull the key out and re-insert it into
the ignition switch at least 6 times within 10 seconds
after Step 2.

4. Open and close the driver’s door once
within 10 seconds after Step 3.

5. The turn signal lights flash 3 times
to indicate completion of the setting.

Edited by brus brother

Share this post


Link to post
Share on other sites

As Fairtax suggested, check your owner's manual. A brandy new 2014?? At the very least, ask the salesman to modify this as a courtesy. If you find the particular sequence for your car, please post it here. Welcome to the board.

I know your model isn't listed at the below link but it has to be one such "simple" fix. Do they really have to make it so complicated?!?

http://www.cars101.com/subaru/keyless.html#08chirp

2009, 2008 Outback Legacy, Tribeca, Impreza

 

Audible Chirp when locking/unlocking

give you an audible signal when the doors lock and unlock. If desired,

you may turn the audible signal off.

 

Do the following to deactivate the audible

signal. You can also use the same steps to restore the function.

 

1. Sit in the driver’s seat and shut all

doors and the rear gate.

 

2. Hold down the UNLOCK side of the power

door locking switch.

 

3. While holding down the “UNLOCK” side

of the power door locking switch, pull the key out and re-insert it into

the ignition switch at least 6 times within 10 seconds

after Step 2.

 

4. Open and close the driver’s door once

within 10 seconds after Step 3.

 

5. The turn signal lights flash 3 times

to indicate completion of the setting.

Is this step-by-step for real?? Do you need to hold your head a certain way too?? I guess I am old school............I would have looked for a wire to disconnect.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×