trikerdon Posted March 27, 2014 Share Posted March 27, 2014 (edited) I have a trike that had a VW engine. I swapped it with and EA82 1988. I took the Weber carb off and put it on the Subaru. Runs great in the lower end but when I give it the gas it bogs down like it is either getting too much fuel or not enough? I didn't re-jet it when I got it just used it right out of the box on the VW. Does any one know what jetting I should use with the EA82? Well, I think I found a cure. It is the Weber K731 carb that is made for the EA82 engine. A little expensive but then I can sell the one I have now which is made for VW's. Thanks for every one's help.... Edited March 28, 2014 by trikerdon Quote Link to comment Share on other sites More sharing options...
Loyale 2.7 Turbo Posted March 27, 2014 Share Posted March 27, 2014 I use 140 in Low and 162 in High, and advanced the Timing to 20º But the Weber conversion kits for the EA82 comes with both mains at 140 Kind regards. Quote Link to comment Share on other sites More sharing options...
ferox Posted March 28, 2014 Share Posted March 28, 2014 http://www.ultimatesubaru.org/forum/topic/144335-weber-jetting/?hl=weber%2Bjetting Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.