Jump to content
Ultimate Subaru Message Board
trikerdon

Weber 32/36 DGEV carburetor jetting

Recommended Posts

I have a trike that had a VW engine.  I swapped it with and EA82 1988.  I took the Weber carb off and put it on the Subaru.  Runs great in the lower end but when I give it the gas it bogs down like it is either getting too much fuel or not enough? 

I didn't re-jet it when I got it just used it right out of the box on the VW.

Does any one know what jetting I should use with the EA82?     

 

Well, I think I found a cure.   It is the Weber K731 carb that is made for the EA82 engine.  A little expensive but then I can sell the one I have now which is made for VW's.

 

Thanks for every one's help....

Edited by trikerdon

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×