Jump to content
Ultimate Subaru Message Board

why would the fans be on from a cold start ? 96 j2.2 l


Recommended Posts

I recently replaced the head gaskets,   but the fans where working normally i believe.   the only other thing i did was degreese and pressure wash the engine and bay.

 

The fans go on from a cold start and stay on..

 

what should i look for?

 

the wire is connected to the censer.   fans are on so it has power.

 

Any advice what it could be ?  Thanks 

 

Link to comment
Share on other sites

If the AC isn't turned on then there may be a problem within the ECU. It controls the fan operation by making a ground connection which turns on the fan relay. If the diagnostic connectors are tied together under the dash that will do it also.

Link to comment
Share on other sites

Is it throwing any codes? If the engine coolant temp sensor is bad or not connected the ECU will run the fans as a failsafe since it doesn't know what the temp is. There's two sensors - one for the gauge, the 'coolant temp sensor', which is not the sensor we're looking at/for. The other is the engine coolant temp sensor - that's the one I'm referring to. (Or as already mentioned if the a/c or defrost is on that will do it too).

Edited by porcupine73
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...