Letters909 Posted April 17, 2017 Share Posted April 17, 2017 Hey guys, I just started the process of redrilling my hubs to make them 6lug and I was wondering if I'll run into issues if I leave my car at stock height. Or if anyone has tire size suggestions for a 15x6 rim that might fit (Im not opposed to cutting out the fenders as much as needed seeing as their already rusted to he'll) Quote Link to comment Share on other sites More sharing options...
BEECHBM69 Posted April 17, 2017 Share Posted April 17, 2017 I've got 195/60/15s wrapped around pugs on my wagon with no lift, and no issues. Dan 1 Quote Link to comment Share on other sites More sharing options...
Numbchux Posted April 17, 2017 Share Posted April 17, 2017 6-lug wheels come in a huge range of dimensions... Keep in mind, Subaru wheels have a very high offset/backspacing. So real low-offset (like most chevy truck wheels) 6-lug wheels aren't going to fit well at all. But stock Toyota ones are close, and I think I've seen some Isuzu and Nissan offerings that are even higher-offset, which would fit well. Tire size will make a big difference, too. ASSuming the car your referring to is the '85 4WD Wagon in your signature, you should have a fair amount of wheel well clearance. 1 Quote Link to comment Share on other sites More sharing options...
Letters909 Posted April 17, 2017 Author Share Posted April 17, 2017 Thanks guys, I could have been more specific in my post but, I've got some alloys from an Isuzu trooper. So hopefully the offset won't be an issue Quote Link to comment Share on other sites More sharing options...
jsyme Posted June 15, 2017 Share Posted June 15, 2017 Letter909, How did the alloys from an Isuzu trooper work out for you? I'm curious about inside fender rub, tire size you chose, and if you have a lift. Would you do it again? thanks in advance. Quote Link to comment Share on other sites More sharing options...
TheGageinator Posted June 17, 2017 Share Posted June 17, 2017 I'm hopefully getting some steel isuzu rodeo wheels tomorrow. I'm planning on drilling the wheels not the Hubs. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.