Downwash77 Posted August 5, 2018 Share Posted August 5, 2018 Just finished my ea81 with new rings and bearing, wondering if there is any break in recomendations, thanks. Quote Link to comment Share on other sites More sharing options...
George1943 Posted August 5, 2018 Share Posted August 5, 2018 Here is a page from a Haynes repair manual For Subarus 1980 thru 1989 Quote Link to comment Share on other sites More sharing options...
carfreak85 Posted August 5, 2018 Share Posted August 5, 2018 We subscribe to the "run it hard" break-in theory. That doesn't mean WOT pulls from the first start up, but we did this method on our last rebuild and it has proven to not use a drop of oil in the last 50k+ miles: Fill brand new engine with either break-in-specific oil or cheap 30w dino oil. Start, idle and check for leaks, drips, new engine type stuff. (optional, stop engine, change oil & filter, cheap dino 30w or break-in specific) Take car for a drive along a route with as much change in elevation as possible, varying throttle positions and engine speed. There is no need for WOT or redline shifting, but DO NOT baby the engine. If its turbocharged, try to stay out of boost, but get as close as you can to 0 in/hg and psi as possible. If N/A, half to 3/4 throttle is acceptable. When you have the opportunity to engine brake from medium high rpm, take it! Use engine braking as much as you can during your break-in test drive. (optional, stop engine, change oil & filter, cheap dino 30w or oil of your choice) Drive normally varying engine speed and throttle position (avoid WOT and high gear, high throttle situations) for the next 1,000-3,000 miles. Change oil & filter. Now you're good to go! 1 Quote Link to comment Share on other sites More sharing options...
GeneralDisorder Posted August 6, 2018 Share Posted August 6, 2018 Cylinder pressure seats rings. Ring manufacturers recommend 2/3 throttle and varied engine speeds. Honestly I typically go WOT after about 50 miles of 2/3 throttle, and closed throttle coasting. There is NO break in for bearings. There should not be any contact on bearing surfaces EVER. GD Quote Link to comment Share on other sites More sharing options...
Knucklehead Saloon Posted August 6, 2018 Share Posted August 6, 2018 Weird GD.... my mech tradie when I was an apprentice told me it took 10k to bed in mains and bottom ends... Quote Link to comment Share on other sites More sharing options...
el_freddo Posted August 6, 2018 Share Posted August 6, 2018 Here we go, my old man always told me it was to bed rings in and that regular small interval oil changes in the first 10k km were essential to remove fine metals from the engine internals to help reduce any permit ute wear on the mains and big ends... Anyone go yet another story about break in procedures? Cheers Bennie Quote Link to comment Share on other sites More sharing options...
Downwash77 Posted August 6, 2018 Author Share Posted August 6, 2018 Thanks, this is what I was thinking, we have the perfect landscape for exactly this type of driving. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.