Jump to content
Ultimate Subaru Message Board

is it possible to swap the ej22 into a newer 2000 - 2004


Recommended Posts

It's electrical mostly.  The wiring from the phase I mani, wont work with teh Phase II ECU.

The phase II Manifolds won't fit the EJ22E.

So, the way to do it is one of 2 ways.

A)  Full harness strip from the donor car, and install like doing an EJ swap in an older car.

OR...........

B )  Swap phase II wiring and throttle body over onto phase I intake.  A block off plate will have to be made that fits between TB and intake, to block off the Idle passage.  Injector connectors will need to be modded/swapped to work on the Phase I injectors.  This will run fine, but will have CEL and won't have warm up idle control so you'll need to hold the gas on cold mornings for a 10~30 secs before will idle.

 

* note, if you are installing into a Manual trans vehicle, you will not have a lower starter bolt......so that would need addressed.  

Edited by FerGloyale
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...