Jump to content
Ultimate Subaru Message Board

Centre bearing supports EJ in EA81 body ??


Steptoe
 Share

Recommended Posts

Need some ideas, photos, tips on how to make a tail shaft centre bearing fit up to an EA81 transmission tunnel

And, for once, I am asking in the most appropriate forum section

I have an EJ20 from AUDM GF8 Impreza sitting in the engine bay with widened slots. It fits.

Then I have the Impreza 5MT AWD box sitting behind it without flywheel and clutch at the moment - working on an H bracket crossmember

So, wondering what others have done to mount the tailshaft centre bearing for full EJ conversions

I have done the flat bar method before using EA82 five speed and two piece tailshafts. Also done another make centre bearing support bracket

The EJ tailshafts centre bearing sits a little further back from EA82 location and it doesn't look so easy

The world is full of EJ conversions but most seem to be engine only with adaptor plates. Unfortunately I got a bee in my bonnet about using more modern driveline...

So, some pics and text would be greatly appreciated

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...