Scottylack Posted January 9, 2020 Share Posted January 9, 2020 Said this was taken off a Brat? Anyone know which engine it was taken off and what carb? Thanks! Quote Link to comment Share on other sites More sharing options...
naru2 Posted January 9, 2020 Share Posted January 9, 2020 It is a Hitachi,but,other details are hard to pin down w/o the carb #. Quote Link to comment Share on other sites More sharing options...
Scottylack Posted January 9, 2020 Author Share Posted January 9, 2020 Like to see if it would fit my 82 not sure if the intake would work Quote Link to comment Share on other sites More sharing options...
naru2 Posted January 9, 2020 Share Posted January 9, 2020 (edited) Probably will.Compare it to your carter weber manifold.I think the 1600s are narrower(shorter). If they are the same length,then the hitachi is for an ea81 like yours. Edited January 9, 2020 by naru2 Quote Link to comment Share on other sites More sharing options...
Scottylack Posted January 10, 2020 Author Share Posted January 10, 2020 Like to see if it would fit my 82 not sure if the intake would work Quote Link to comment Share on other sites More sharing options...
Scottylack Posted January 10, 2020 Author Share Posted January 10, 2020 Intake says SK 16 ?? Quote Link to comment Share on other sites More sharing options...
GeneralDisorder Posted January 10, 2020 Share Posted January 10, 2020 Very likely a later model EA81 intake. No thermostat housing so it's not EA82. It's got the AC idle up pot so probably a later Brat with the EA81. GD Quote Link to comment Share on other sites More sharing options...
Scottylack Posted January 10, 2020 Author Share Posted January 10, 2020 Like to see if it would fit my 82 not sure if the intake would work Quote Link to comment Share on other sites More sharing options...
Scottylack Posted January 10, 2020 Author Share Posted January 10, 2020 More pics Quote Link to comment Share on other sites More sharing options...
Scottylack Posted January 10, 2020 Author Share Posted January 10, 2020 Quote Link to comment Share on other sites More sharing options...
el_freddo Posted January 10, 2020 Share Posted January 10, 2020 It’s an EA81 intake looking at the location of the thermostat housing - as GD said. I’m not up with the width measurement of these intakes so can’t help there. If you fit this to your EA82, you’ll need to run the EA81 upper radiator hose. You’ll also drop a bit of power but probably not notice. This is due to a smaller carb. They look the same but the EA81 is actually a bit smaller - you can’t swap them between EA81 and EA82 or vice versa without an adaptor plate or other mods. Cheers Bennie Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.