Jump to content
Ultimate Subaru Message Board

Customized Swing Arms


chris1
 Share

Recommended Posts

So I'm considering building my BRAT with new swing arms / A.
I'm going to widen the position a little (less than an inch so as not to mess too much with axles) to add some extra adjustment points for camber and caster and perhaps adjust the lower spindle mount to allow a better / sturdier ball joint mount.

Once I draw it, I'll get a picture up.

I'll probably use the mounts in the factory so that bushings don't change or I can go with an upgraded bushing design.

It's based on what I can easily get.

Any suggestions before I draw?where am i 192.168.8.1 192.168.100.1

Edited by chris1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...