Jump to content
Ultimate Subaru Message Board

Some XT6 Questions


Recommended Posts

I have a mostly intact steering column clamshell from a 1986 XT 4 cylinder and one for an XT6 with the right side of the top piece broken. Is it possible to have these scanned so I can have the full part with the gap for the windshield washer stalk? Also, has anyone put 19" wheels on an XT6 (or other ea82)? Any mods required?

Link to comment
Share on other sites

10 hours ago, linkthehero1234 said:

I have a mostly intact steering column clamshell from a 1986 XT 4 cylinder and one for an XT6 with the right side of the top piece broken. Is it possible to have these scanned so I can have the full part with the gap for the windshield washer stalk? Also, has anyone put 19" wheels on an XT6 (or other ea82)? Any mods required?

"scan", for 3D printing?  Yes it can be done for hundreds of dollars. 

Not all XT(6) steering column covers are interchangeble.

Total tire diameter depends what struts you have. 225/60/16 tires on mine now would allow for 19" if they're low profile.  But again itll depend what struts you have.  Most are converted to something else by now, if you have impreza struts up front you'll be more limited.  

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...