Jump to content
Ultimate Subaru Message Board
Phizinza

Leone dash in a Brumby, problems

Recommended Posts

I have a Brumby/Brat that has an Leone dash (for the tacho mainly, I think, I didn't put it in.) the voltmeter reads about 11.5V's most of the time (multimeter reads 13.8V off the battery), the tempmeter doesn't move from 0 unless I rev the engine alot, the oilpresure meter does the same as the tempmeter and the speedo reads higher then I'm going, which isn't too bad as I'm putting bigger tyres on it for offroad so it might get back in to the right speed. What can I do the fix the gadges reading low expet the speedo?

Share this post


Link to post
Share on other sites

I would start by making sure everything is grounded properly and using sending units compatible with the gauges.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×