Jump to content
Ultimate Subaru Message Board

lets get some control arm and axel specs together


Recommended Posts

i thought it might be usefull to get the axel lenghts front and rear and also the front control arm lenghts..

 

 

ill get the gen 1 stuff as thats all i have right now........

 

 

we need gen 2 and gen 3 (loyal) stuff

 

also maybe tierod ends (inner and outer)

 

the reason is so it will be easyer to mix and match.

Link to comment
Share on other sites

for axles with 25 splines, the doj from a 3at turbo axle can be swapped on for use with 23 spline trannies. its the same diameter as the 25 spline doj, but has 23 splines. the 3at turbo is the only 23 spline large diameter doj.

 

sometimes when you buy a remanufactured axle you may get a 3at, it has a the same shaft diameter as 25 spline turbo axles, 3 bands on the outer end. i have seen 3at axles on other models because the original axles have been changed out

Link to comment
Share on other sites

the 3at turbo is the only 23 spline large diameter doj.

 

I am almost certain that the New Zealand ea81 vehicles were all fitted with the large CV joints (DOJ - what does that stand for???). The vehicles imported second hand from japan (lots of them) have the small ones (except the turbo ones). Strange.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...