Jump to content
Ultimate Subaru Message Board

Towing a 79 4WD with a tow bar


Recommended Posts

I'm considering towing a 79 4WD wagon 900 miles with an adjustable tow bar. Has anyone tried this? What experience has anyone had? any suggestions regarding whether or not to disconnect the shafts all around? just the front? Thanks, Cricket

Link to comment
Share on other sites

I'm considering towing a 79 4WD wagon 900 miles with an adjustable tow bar. Has anyone tried this? What experience has anyone had? any suggestions regarding whether or not to disconnect the shafts all around? just the front? Thanks, Cricket

 

the old ones with manual trannies like that can be flat towed without removing any shafts. just make sure you are in 2WD and Nuetral. and make sure the steering wheel isn't locked.

 

lots of soobies were flat towed behind motor homes in the 70's/80's.

Link to comment
Share on other sites

To repeat what everyone else said.. leave it in FWD, shifter in neutral and ride. Keep up with those tires though, and make sure the steering is unlocked.

 

BTW, its a 5 speed? I remembered reading that the EA71s came with 4 speeds. Am I wrong?

Link to comment
Share on other sites

Well, now I don't remember if it's 5 or 4 speed. I'm looking at a tow bar that supposedly attaches right to the bumper bolts and doesn't need a "bracket." Which is why I was asking about it.

 

 

 

To repeat what everyone else said.. leave it in FWD, shifter in neutral and ride. Keep up with those tires though, and make sure the steering is unlocked.

 

BTW, its a 5 speed? I remembered reading that the EA71s came with 4 speeds. Am I wrong?

Link to comment
Share on other sites

i towed a sedan from fort wayne indiana to hillsdale michigan with my ea82 sedan, in the snow, 4wd and 45 mph. did ok

 

towed a wagon to the junk 20 miles 55-60 mph no problem

 

future plans involve towing a wagon across iowa 400 miles, with the ea82 sedan, 5spd dual range no driveshaft lo when needed

 

the tow bar i have was modified to fit any ea82 body in a non permanent fashion, to tow with an ea82 or ea81 with a hitch. or anything with a hitch for that matter

Link to comment
Share on other sites

  • 3 weeks later...

just make sure its in neutral... a guy towed a sami behind a motor home while the car was in 1st... went up to like 20000rpm... not good...as long as its not an automatic you can tow it as far as you want...

Link to comment
Share on other sites

Just remember ....

 

 

You can NOT back up while the car is connected to the

 

tow vehicle.

 

 

some lessons in life are learned the granite way

 

 

Not even if the tow'd vehicle is running?As in idling in neutral.

Link to comment
Share on other sites

" Not even if the tow'd vehicle is running?As in idling in neutral."

 

If this comment was directed at my statement??

 

Please be advised, the comment I made has nothing to do

with the drivetrain of the tower vehicle.

 

But is directed at the fact that....

 

The front wheels will cock and jack the knife

will occur within meters.

 

as I said - the the path to knowledge is sometimes strewn with

Gibraltars

Link to comment
Share on other sites

" Not even if the tow'd vehicle is running?As in idling in neutral."

 

If this comment was directed at my statement??

 

Please be advised, the comment I made has nothing to do

with the drivetrain of the tower vehicle.

 

But is directed at the fact that....

 

The front wheels will cock and jack the knife

will occur within meters.

 

as I said - the the path to knowledge is sometimes strewn with

Gibraltars

 

It was a question,not a comment.

Link to comment
Share on other sites

" Not even if the tow'd vehicle is running?As in idling in neutral."

 

If this comment was directed at my statement??

 

Please be advised, the comment I made has nothing to do

with the drivetrain of the tower vehicle.

 

But is directed at the fact that....

 

The front wheels will cock and jack the knife

will occur within meters.

 

as I said - the the path to knowledge is sometimes strewn with

Gibraltars

How about if someone gets out and helps keep the wheels from cocking? :brow:

P.S. Flat Towed an 84 brat from San Diego to Tucson behind a 1-ton F250 Turbo Diesel.

Link to comment
Share on other sites

If the person in the towed vehicle tries to correct ...

 

the towed vehicle will try to streer the towing vehicle via

 

the tow hitch

 

This is not good in some situations.

 

P.S.

coachandrosey.JPG

Link to comment
Share on other sites

Update. See thread about towing disaster (which had nothing to do with the tow bar setup): http://www.ultimatesubaru.org/forum/showthread.php?t=37058Anyhow, I drilled four 1/2" holes (2 per mounting bracket) right through the front of the bumber, as close as possible to the bumber's brackets. Then I attached the tow bar brackets at the holes. Hooked everything up and it worked just fine. I even went up a pretty steep incline in Colorado Springs just before the mishap described in the other thread. My biggest concern was whether or not the tow bar bracket bolts would come right through the bumper metal under pressure. The bolts/brackets held up just fine.

 

Thanks for all the help about towing. I'll be back in Colorado Springs next weekend to bring the wagon. Again.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...