Jump to content
Ultimate Subaru Message Board
Sign in to follow this  
BoostedBalls

Aftermarket ignition module installation.

Recommended Posts

I have a Crane Cams Fireball ignition ready to drop into the RX. Has anyone on here used a similar setup with the stock distributor? I'm guessing it's a magneticly triggered distributor, right? If so, should be easy.

Share this post


Link to post
Share on other sites

i think the disty in the rx is optically triggered, eithe that or a hall effect switch. if you look under the plate that goes under the rotor, there is a thin metal disk with tiny little holes along the edge of it, that passes through a pick up, looks like its an optical pick up.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×