Jump to content
Ultimate Subaru Message Board

Need FSM directions for diff bearing set-up


Recommended Posts

I need to do the bearing preload on a rear differential. I can't use the original shims as they got mysteriously damaged(that means melted) when I was torching off the stub shaft with a stripped torx bolt*. Does anybody have the FSM describing this for the R160 diff? The actual unit is from an 89 but I doubt that is overly significant.

Thanks, Brad

 

* the acetylene torch is not a good tool for this task. Next time I'll stick to the trusty sawzall.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...