Jump to content
Ultimate Subaru Message Board
Sign in to follow this  
bgambino

source4bearings4 T belt idler pulleys???

Recommended Posts

I'd like to get new bearing and have them pressed into a couple of my idler pulleys (96 DOHC 2.5 OB)....especially the toothed idler...I bet this sucker is costly

Went to car quest..they looked up he bearing numbers I gave them and said no good

Anyone?

Also....is 1st subaru still in existence? I thought they sold OEM parts about 10% over cost.

Someone said there is a difference between the website and calling in (differing prices)

thanks

Share this post


Link to post
Share on other sites

your best bet would be to get the numbers off the face of the pulleys and any bearing supply house can match those numbers with the correct bearings.

 

if i were you i'd get an entire set of used pulleys. i'm sure there are plenty lying around, i have some from a 2.5 SOHC sitting somewhere. post in the parts wanted forum or find a junkyard that has a bad motor. or go to a pull it yourself yard and get a set of old pulleys. get these all rebuilt that way you have new pulleys ready to go when you do the timing belt job.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×