kayakertom Posted June 17, 2006 Share Posted June 17, 2006 Is there any ecu signal modification needed when swapping out an auto trans to manual in order to tell the ecu that it is now a manual? The car is an '87 gl 3-door with spfi. Have removed the auto trans, installed a 3 pedal assembly and replaced the speedo cable with a longer one. Have the needed color matched trim pieces and longer driveshaft. Keeping the original instrument cluster and just putting black tape over the auto trans indicator part. The d/r replacement trans is almost ready to go in - just need a replacement 4wd switch (long one at the rear of the trans is broken). Getting the donor flywheel resurfaced next week. For wiring mods, I am jumping the thick black wires in the auto trans connector to enable the neutral position signal to allow starting. Still need to figure out how to wire in the reverse switch for back-up lights. The d/r trans I am installing just has two switch holes, while the high mileage one from the parts wagon has 3 switches - what's the 3rd one for? Quote Link to comment Share on other sites More sharing options...
calebz Posted June 17, 2006 Share Posted June 17, 2006 I did the tranny swap on my 87 turbowagon and there was no change in ECU needed Quote Link to comment Share on other sites More sharing options...
Steveman09 Posted June 17, 2006 Share Posted June 17, 2006 I did the swap in my 87 GL10 and if you dont have cruise no ECU mods needed, if you do have CRUISE and WANT it to work you have to jump the Identification Pin like I did to enable cruise after the swap. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.