Jump to content
Ultimate Subaru Message Board

Recommended Posts

i just put my engine in, the front mounts are bolted down, it's firmly anchored to the tranny. my exhaust is sitting about a quarter inch back... why is that? it certainly seemed to fit when I disconnected the y-pipe from the engine. tried having my dad push on the muffler tip, and pulling on the y-pipe at the same time with little results. I never even took the exhaust off the car. any ideas?

 

-jordan

Share this post


Link to post
Share on other sites

try getting under the car and wiggling the rubber mounts further back on the exhaust pipe's mounts, they may just need some slack in order to let the exhaust move forward. Also make sure it's not rubbing on anything under there.

Share this post


Link to post
Share on other sites

Probably bent the bolt-on hanger that hangs the rear of the y-pipe under the trans. It's a hard mount, so no rubber - take it loose and it should come forward.

 

GD

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×