Jump to content
Ultimate Subaru Message Board

GL-10 work bench


s'ko
 Share

Recommended Posts

So had this GL-10 that I scrapped and I had the trunk left over.

 

so with a welder and a butt load of scrap steel around you can built anything..

 

Took two 2 inch angle pieces and welded then to the rear of the trunk lid.

Took a long 1/2 square tube and welded it between the two angle pieces. This formed the anchoring point for the rear of the table.

Made some braces out of 1" x 1/2" solid bar and then secured them to the 2x4 in my garage. Placed the trunklid on top and then used a c-clamp to secure the braces to the rear bar. Weld to pieces together. Then weld the front of the braces to the trunk lid. I made the table about hip height so it's comfortable to work with while standing up.

 

Will take pictures tomorrow b/c it's took dark.

 

welders rule....:headbang:

 

BW

Link to comment
Share on other sites

  • 2 weeks later...
  • 1 month later...

ok so here are some pictures.

 

IMG_0006.jpg

 

here is a picture of the brace

 

IMG_0007.jpg

IMG_0008.jpg

 

One more thing that I did w/some left over parts.

I took a gas tank and some steel wheels and made a parts cleaner.

 

IMG_0009.jpg

there part in the cleaner is 1/2 of an ea81 block. Here is the other half all nice and clean.

IMG_0010.jpg

 

BW

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...