Jump to content
Ultimate Subaru Message Board

How big a job to install cruise in "90 legacy


Recommended Posts

easy job! Absolutely make sure you get the right cruise computer for the right transmission in the car (auto trans CC computer will not work on a manual trans car)

 

You need:

-the cable and articulator that goes under the hood

-the correct CC computer

-the switch you put into the dash

-the switch you put in the steering wheel (you do not need the whole wheel)

-brake light switch

-clutch switch

 

 

Notice I didn't say anything about wireing....'cause it is already there!!!!!!

 

All parts are easy to find and the computer location is to the right of the glove box (you have to remove the GB) and ti is a little bit of a pain in the a$$ to get at but not too bad. All parts are interchangable with automatics/manuals EXCEPT the actual computer. You need to make sure all the parts come from the same generation of legacy...you are interested in 90-94 only.

 

Believe it or not this is super easy to do!!!!! if you know what you are doing it is an hour tops seriously since it is all "plug and play"

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...