Jump to content
Ultimate Subaru Message Board
Brettm57

'95 Legacy heater fan control, hard to replace?

Recommended Posts

My '95 Legacy fan control has just 2 speeds now, high and off, and needs to be replaced. My question is, how much of the dash do I have to tear out to get to the control? It looks like maybe I can just pull the small panel that the control is mounted on (I hope!)? Thanks.

Share this post


Link to post
Share on other sites

You likely need a to replace a resistor pack (or repair the old one if it's just cracked solder). That part is inserted into AC evaporator case, for cooling, and held by a flange with two screws. For access, remove the glove box and the reinforcement stamping behind, if present.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×