alia176 Posted December 7, 2003 Share Posted December 7, 2003 Hey guys, Those of you with the OTC hubtamer tool p/n 6490, can you help me out? I'm in the process of removing the rear bearing and a little stuck. I'm puzzled as to why the "forcing screw" 503052 isn't going into p/n 311881 easily. Could I have a bad p/n 311881? The threads on both parts look clean and not galled. It almost feel like the thread on p/n 311881 is slightly tapered. I'd say only about 1/4" of the forcing screw goes before it becomes extremely tight. I used the forcing screw to remove the outer hub with ease so I know the screw is in good shape. Thanks for any help. Ali '95 Wagon Quote Link to comment Share on other sites More sharing options...
99obw Posted December 8, 2003 Share Posted December 8, 2003 Those two parts go right together with mine. Be sure to grease the screw when using it. You may have a bad part. Best of luck. Quote Link to comment Share on other sites More sharing options...
alia176 Posted December 8, 2003 Author Share Posted December 8, 2003 Yeah, I suspect one part was not tapped well from the manuf. I still got the job done using the supplied non hardened nut but I prefer to have all parts working...specially for the cost of this tool! Sure is a nice tool though. Ali Quote Link to comment Share on other sites More sharing options...
alia176 Posted December 8, 2003 Author Share Posted December 8, 2003 I talked to OTCTOOLS.COM cust service today and they'll be sending me another p/n 311881. No questions asked! I'm still reeling from it :-p Ali Quote Link to comment Share on other sites More sharing options...
99obw Posted December 8, 2003 Share Posted December 8, 2003 That's great! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.