Jump to content
Ultimate Subaru Message Board

HVAC controls backlighting


Recommended Posts

Hi, I recently acquired a 98 OBW. I can't remember if my old 94 Legacy had this issue or not, but the HVAC controls are impossible to read at night because the only lighting they have is the little lights below each button for the mode controls, and I don't think the fan or temp controls light up either.

 

Is this normal or do I have a bad hvac control module? Does it have replaceable bulbs?

 

Thanks folks.

Link to comment
Share on other sites

Search around here. Some links to excellent writeups. I just get the 3 Suby bulbs at the dealer rather than going the Radio Shack route.

 

Dave

 

There was a previous write up last year on how to disassemble the dash to gain access to change the bulbs. Pictures were included to make the instructions very clear. Do a search on this forum to find this information. It did not look like a difficult project.

Link to comment
Share on other sites

Ah I see where those bulbs are. Shouldn't be too hard.

 

It will be interesting to find out if these were burned out from age or from careless spills, as Kudd mentioned. I know my wife has aleady managed to spill soda in there, making the a/c switch stick a bit :slobber:.

 

Thx folks!

Link to comment
Share on other sites

I think they just burn out.

 

I don't know if that link has the suggestion to disconnect the cable at the floor rather than the back of the controls - but I highly recommend it.

 

I had the Radio Shack bulbs in hand the first one of these that I did. I couldn't get the rubbers off the burnt bulbs - they seem to get burnt on there. All 3 bulbs at the dealer (I forget 1 big, 2 small - or 2 big, one small) are under 20 bucks.

 

I gave the RS bulbs to another board member. Anymore I just get the dealer bulbs. I seem to do one of these per month.

 

Dave

Link to comment
Share on other sites

Yep. And they have the little plastic base on them so no messing with bulb wires like on the RS bulbs.

 

So I treat myself to dealer bulbs. No rubbers, no bulb wires. Sometimes it's just worth it to me to spend a few extra bucks - and this in one of those cases for me.

 

Dave

Link to comment
Share on other sites

Hi, I recently acquired a 98 OBW. I can't remember if my old 94 Legacy had this issue or not, but the HVAC controls are impossible to read at night because the only lighting they have is the little lights below each button for the mode controls, and I don't think the fan or temp controls light up either.

 

Is this normal or do I have a bad hvac control module? Does it have replaceable bulbs?

 

Thanks folks.

 

I have a 93 legacy and 94 legacy and they are both backlit on the letters and the little light. I did have the bulbs in the 93 go bad at one point though.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...