Jump to content
Ultimate Subaru Message Board
Sign in to follow this  
BigAl

Rear bushing help (88 GL 4x4)

Recommended Posts

So I have been searching online for the better part of the morning for a bushing that either doesn't exist or no one sells. I am not sure if it is considered a trailing arm or a rear control arm. But long story short, the right rear wheel on the wagon has taken on an excessive amount of negative camber, and I have traced it back to a dissolved bushing on the right rear arm. I have tried searching online for both a trailing arm bushing or a rear control arm bushing to no avail. Any suggestions or recommendations on where to get these? It is pretty much holding up my alignment, so I am hoping to get one by the end of the week. I will try to get a picture by tomorrow afternoon to better clarify. Thanks in advance. :)

Edited by BigAl

Share this post


Link to post
Share on other sites

I Came across that Problem Before: You must Change the Whole Part -the control Arm- that Holds the Bushing, `cos it is Part of it.

That`s Why you Couldn`t find it as Replacement Part.

 

Kind Regards.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×