like it says, trimmed loom. main and fuel relays clicking (ecu controlled).

 

i have power at my injectors but not my ignighter/coil? is this on the same power supply as my injectors or another source?

 

i have it hooked up on the floor trying to get spark, power is through the main relay and im hooking up the ing wire from the ecu to switch it all on.

 

can i jump a wire to the coil and ignighter? or which coloured wires should i be tracing? i just need spark

 

this is 1990 ej22 wiring (auto if it makes a difference)

You need to find the yellow wire from Coil and Igniter, and reconnect it to the Ignition switched wire for the Ig. Relay.

(that wire should also have been a yellow feeding a few sensors and solenoids power, and then, going into a diode, then out as Light Green to the ECU "on")

 

The way the harness is setup, many folks cut this wire as it's junction is way up near the underhood fusebox. It's alright, it kinda needs to be cut and spliced longer to make the harness work elegantly anyhow.

haha thanks, but i already did this while waiting on reply.

i have spark at each plug :banana: