tanner93loyale Posted October 7, 2015 Share Posted October 7, 2015 I tried to install a new stereo and cut all the wires from the plug where the den is, tried saldering them to my new stereos wires and it didn't work along with my dash lights and power seatbelts not working. Any ideas of what wires are for what? Quote Link to comment Share on other sites More sharing options...
zmarrott Posted October 8, 2015 Share Posted October 8, 2015 did you disconnect the battery before attempting? if not you may have shorted something durring the installation. make sure to check all your fuses. ive blown more than a few by playing with wires with the battery installed. however if you did remove the battery, then i would think you may have crossed something or grounded the wrong wire which could causes strange electrical issues. take a look at this page if the loyale is the one your usrname refers to: http://www.modifiedlife.com/1993-subaru-loyale-car-stereo-wire-diagram/ ive gone to that site on a few occasions while setting up stereos in my cars Quote Link to comment Share on other sites More sharing options...
tanner93loyale Posted October 10, 2015 Author Share Posted October 10, 2015 Thanks. No I didn't disconnect the wire. And I checked what seemed to be the right fuse but I will check them all to make sure. Quote Link to comment Share on other sites More sharing options...
tanner93loyale Posted October 10, 2015 Author Share Posted October 10, 2015 Didn't disconnect the battery* Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.