mattdni

The wheels are from a 2003 impreza (i think). I am putting them on a 91 legacy. They have decent clearance when they are straight. I have not tested them on the road, so I don't know if they will clear while turning.

When I was putting these wheels on my car I noticed that the nuts did not go all the way onto the threads. (see picture) I am concerned that the nuts may back themselves out. Before I test out the wheels on the road, I would like to know your opinion on the issue.

I was not sure where to put this thread so I hope I chose the right category. I have a 1991 Subaru legacy that needs a few things and I wanted some opinions on what I should do. Right now it needs struts, inner tie rods, a new outer cv boot on the front right, and an alignment. I found that these will cost about $570 if I do some of the work myself. I have a few questions now that you know my situation. How much do you think my car is worth now and also after I fixed it? It is in decent cosmetic condition. My wheels are stuck on and I would like to know if you have any suggestions on getting them off. Right now I have only tried hammering from the back of the wheel but I have heard that loosening the lug nuts just a bit and then turning hard at very low speeds can help. Do you have any other suggestions?