99 Outback Sport

So I went to the junk yard and got new knuckle for $60.

Thank you. I was hoping to put the old axle back in again but now the "U" joint is stuck at a downward angle and will not go back into tranny. SMH

So i am trying to remove the CV axle from my 99 OBS. it came out of the tranny no problem. but the wheel side is a bear! I have tryed spraying WD40, heating, PB break, beating it with hammer. it just wont come loose. any suggestions? And yes I removed the 1 1/4" axle nut first.

GG. I managed to get the gaskets / grommets (Fel Pro) at Auto zone at a reasonable price. The place i usealy goto cost about 20% more for same thing. It went pretty smoothly, took me about 3 hours to complete. The hardest part was getting to the back bottom bolt on both sides. The left valve cover was a bit tricky too manuver out / in but I just took my time. Takeing out the battery and wiper jug helped alot. Thanks again for your help. 99 Outback Sport AKA Gary

Thank you again. That is very helpful. I will be checking YouTube for DIY video. God I love the internet.

Thank you.

So I was poking around the engine in my 99 OBS. after pulling out one of the plug wires / grommet I noticed a bit of oil in the gap between the head and block. I check three of the four plugs and they all seem to have same issue. I also notice hot oil smell from engine as well. What could be problem?

Hello everyone. First time Subaru owner. 99 Outback sport, just purchesed a week ago. I am looking forward to picking brains, and learning names.