Nahixson

Thanks everyone, i got it running today. I guess it just needed to blow some spoob out of the exhaust? It runs great. and Thanks to MR Loyale for coming over to lend a hand!

It cranks, kinda stumbles. But doesn't really get close to starting.

MAF is plugged in and clean, rotor screw is in place. I followed the procedure and it went in as it should. how would I check if I was 180 off?

My buddy is bringing me a compression tester this evening, it will not try to start with starter fluid.

I recently bought a '92 Loyale for cheap because it had blown head gaskets. I pulled the engine and did head gaskets, timing belts, and a few other gaskets. The timing belts are on correctly, i am getting fuel, coil tested good, and i even tried a different distributor. I am at a loss! Any suggestions would be appreciated. Thanks!