Skip to content
View in the app

A better way to browse. Learn more.

Ultimate Subaru Message Board

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

code p0102

Featured Replies

Impreza wont keep running, got the code saying MAF low input, cleaned the MAF sensor anyway just because, keep getting the code. How do I deal with this "low input" issue?

  • Author

should I assume that "low input" would be electrical going TO the MAF sensor as opposed to the MAF itself?

Low input is probably low input voltage to the MAF. My computer is being a beeyatch or I'd give you the wire diagram to show you which pin to check.

Try unplugging the wire connector and check for corrosion/dirt on the pins.

  • Author
Low input is probably low input voltage to the MAF. My computer is being a beeyatch or I'd give you the wire diagram to show you which pin to check.

Try unplugging the wire connector and check for corrosion/dirt on the pins.

 

Thanks, I do have a used test MAF sensor coming tomorrow or Sat. but I did not think that the MAF unit is actually the problem, that is why I am here asking for more input.

  • Author

Got a used MAF sensor delivered today. Installed it and the car would not start but was firing. After 3 long tries it started and took 3-5 seconds to smooth out.and then I decided to walk away after a few minutes, made a bowl of cereal, checked on the car which was still running, went to eat the cereal and then found the car still running!!!!! Eventually I felt confident that it would keep running and went for a short spin and it ran great, first time out of the yard since October. I came back, cleared the code restarted it, checked for codes, no more code! My OBD scanner had been getting a red emissions light, it is now yellow. On Sunday I will have to really do some driving to get it to cycle all the way through.

 

Regarding the MAF sensor. My original one had a 3 wire connector at the harness but 4 prongs in the sensor. The replacement sensor still had the harness connector attached, it had been snipped off from the harness. This connector had 4 wires and the sensor itself has 5 prongs!!!!????

 

From what I see, this style of MAF sensors all start with #22680 aa160, then a second set of numbers varies. Some end in RA0, others in 160. Anyway, my car is running even with extra prongs that are sucking wind.

Please sign in to comment

You will be able to leave a comment after signing in

Sign In Now

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.