I tried searching this here and on google, not much luck at all.

I'm working to get the float set properly on my hitachi EA81 carb. I've done the trial and error method with little success. I am really good at disassembling the top fo the carb and would rather set it one last time and be done with it. That being said, does anyone have the spec dimension for the float level? I tried 11mm which is the only spec I could find that was for an SVX. Probably not right since it stumbled and ran rich. I know the sight glass should help me, but I can't see the fuel through it, any tricks there?

 

Thanks to anyone who can help me, if I get this set properly it will pass CA smog test

Think I found what I needed, on an atuozone website no less. Last place I would have looked.

 

http://www.autozone.com/autozone/repairguides/Subaru-ff-1-1300-1400-1600-1800-Brat-1970-1984-Repair-Guide/Carbureted-Fuel-System/Carburetor/_/P-0900c15280065ae8