Does anyone have the programming procedure for a 98 Forester? It has the rectangular remote (made by Code Alarm, as I understand) with the two square buttons.

 

Thanks much!

Hey Bob,

 

Here are the procedures:

1)open driver's door

2)turn ignition to ON position

3)Press and hold the emergency override - located underneath the driver's side dash, below and to the right of the fuse access cover (coin tray) - for about 15 seconds. The door locks will cycle three times indicating that it is in program mode.

4)Press the LOCK button on he transmitter. The door locks will cycle once.

If you have the security upgrade, the system will chirp 3 times in step 3 and once in step 4.

5)Repeat step 4 for any additional transmitters.

6)Exit the programming mode by releasing the programming button.

 

Hope this helps.

Thank you very much, hohieu! I appreciate the assistance.