I have a 97 impreza 2.2, my blower only works on high. I have checked the switch which is working fine and replaced the relay in the &%$@#$ spot under the dash, still no luck. when i turn the switch from off to 1, i can hear the click of the relay, but no fan. When the switch reaches the #4 position, the blower comes high. Any thoughts?

Mikeintenn

Your drop resistor has popped the breaker that is inside your drop resistor ( it has desoldered it's self) It is located in the heater housing behind the glove box ( white 4 terminal connector) pull it out and carefully pry between the white plastic peice that the connector plugs into and the partical board that is attached to the square cage . Once you have the white plastic peice off , straighten out the tabs that are bent over , pry the partical board off the cage . The resistor will come with the partical board , there should be a peice of solder floating around in the cage . You should see a loop on the resistor that is the breaker it should be lifted off of where it should be soldered. Just solder it back on

 

NOTE: if it pops again you may have a problem with you blower motor drawing to much current

 

SEA#3

boy i wish you posted this a month ago, i woulda saved $50.00

 

 

 

lol Mark