vtboy Posted October 19, 2004 Share Posted October 19, 2004 i pulled my cv shaft but now i cant get the pin to line up its a new shatf and pin any help would be great i can get it were i can drop my 3/16 punch right down it but still the pin wont go Quote Link to comment Share on other sites More sharing options...
PeterD Posted October 19, 2004 Share Posted October 19, 2004 i pulled my cv shaft but now i cant get the pin to line up its a new shatf and pin any help would be great i can get it were i can drop my 3/16 punch right down it but still the pin wont go there is only one way the cv will slip on the splines so the pin will fit. try and rotate the axl 180degrees ether that or your a spline off and need to rotate it just a little bit more ether way. thats what i found out when i changed mine this summer. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.