January 25, 200620 yr Hi I have a 91 awd legacy wagon. Im replacing the front passanger side spindle. Can anyone tell me how to remove the abs sensor on the back of the spindle ? thanks bmac_1277
January 25, 200620 yr There should be a bolt that holds it into place. However with time they get rusted in there. So you may need to squirt a lot of penetrating oil in there and try to gently tap it out.
January 25, 200620 yr Author There should be a bolt that holds it into place. However with time they get rusted in there. So you may need to squirt a lot of penetrating oil in there and try to gently tap it out. thanks legacy777 those buggers were in so snug I was worried id ruin the seal on the sensor. so I took the new spindle with an abs already on unplugged the old wiring thru the firewall and hooked up the new connection from the new spindle. getting access to the wiring harness in the engine copartment was no easy feat. after removing all kinds of brackets by the abs system i accessed the harness.
January 25, 200620 yr Author There should be a bolt that holds it into place. However with time they get rusted in there. So you may need to squirt a lot of penetrating oil in there and try to gently tap it out. one other question.... where do you access the abs wiring connector for the passenger side rear wheel ? my fear that it will be inside the car under the carpet running up to the front.
January 26, 200620 yr Author Under the fold up part of the rear seat(that you sit on) i believe. thanks id be tearing up carpet
January 27, 200620 yr Yeah....if you follow the brake lines, and see where they go into the cabin, there is another rubber grommet that has the ABS sensor wiring going to it.
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now