Jump to content
Ultimate Subaru Message Board

Bent bellhousing stud, advice?


Recommended Posts

Whoops! While pulling my transmission out of the Loyale this morning I let the trans drop too far and bent one of the studs on the bellhousing of the engine. What should I do about this? I know the new trans will fit on it, but what about getting the nut on there?

Link to comment
Share on other sites

If you didn't mangle the threads and can get the tranny into place the nut should still run okay on the stud although it might bind a bit at the bend.. If not then use another stud or a different bellhousing. EA-82 bellhousings are the same for MT and AT for what thats worth.

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...