Jump to content
Ultimate Subaru Message Board
stickedy

Switching a digital dash from MPH to KM/H (or vice versa)

Recommended Posts

There is jumper (in fact it's a connector with two pins and a piece of wire between this two pins.) inside the dash. You can reach it without pulling the whole dash! Just loosen all the little srews around the transparent plastic cover and take away piece for piece. Then you will see this jumper.

 

Installed = MPH

Uninstalled = KM/H

 

It will only take about five to ten minutes.

 

And when the cover is already away, you can take the opportunity and clean everything with some dry cloth.

 

This will apply to digital dashes for EA82 of 1987 and later (the green ones).

Share this post


Link to post
Share on other sites

×