Jump to content
Ultimate Subaru Message Board

Recommended Posts

I am trying to learn how to install A trailer brake controller for my Subaru Forester 2000 s series. also open to any advice on traveling across the country pulling a travel trailer. The trailer weighs 2000 lbs

Link to comment
Share on other sites

There will be instructions with the controller (assuming you buy new) for how to connect the wiring and set it up.

 

2000 lbs is a pretty big chunk to lug around. If the car has an automatic trans I would suggest adding an auxiliary transmission fluid cooler.

  • Like 1
Link to comment
Share on other sites

how to install a brake controller will be specific to the brand & model of controller - follow the instructions for your model.

If you dont have them (purchased used?) you may be able to find them online by doing a google search for the brand & model you have.

 

basics are:

fused power source (direct from battery)

brake switch tie in (ours had a splicer in the kit)

wiring to rear of car

proper trailer plug in (car side) to get power to the trailer brakes & lights - ours required a round 7 pin connector

 

is the 2000 lbs just the trailer weight (empty)? or is that gross weight (fully loaded)? either way, that is a lot of weight for a Subaru, and I agree with Fairtax - an external tranny cooler could be very helpful.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...