Jump to content
Ultimate Subaru Message Board

2005 Forester Compressor Seized


Recommended Posts

Troubleshooting remotely, so bare with me.

Father-in-laws compressor seized, smoked and melted the drivebelt.  he is wondering whether he can run the car without that drivebelt.

 

there are 3 pulleys on that belt: AC, Crank, and something I don't know.

Is the lower one just an idler or is that important?

 

Thanks.

Link to comment
Share on other sites

Compressor clutch has to be engaged for the pulley to drive the compressor. If the AC is off the outer pulley should spin easily.

Normally you should be able to rotate the center hub of the compressor (that part with the three straps on the front) by hand easily. If the hub can't be turned by hand, then yes, compressor is locked up. You can leave that belt off entirely and it won't affect anything.

 

Do check the lower idler pulley. Much more likely for that to seize, and it's a lot cheaper than a compressor.

Link to comment
Share on other sites

  • 2 weeks later...

If you can't spin the outer part, the pulley bearing may be locked up or something in the clutch could have jammed.

Try spinning the hub, if you can spin that by hand the compressor may be OK internally.

You can remove the pulley with a special puller and see if the bearing locked up or if there is something jammed in there, but if the pulley locked up there's a good chance it has overheated the compressor and caused it to grenade inside.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...