Welcome to Ultimate Subaru Message Board, my lurker friend!
|Welcome to Ultimate Subaru Message Board, an unparalleled Subaru community full of the greatest Subaru gurus and modders on the planet! We offer technical information and discussion about all things Subaru, the best and most popular all wheel drive vehicles ever created.
We offer all this information for free to everyone, even lurkers like you! All we ask in return is that you sign up and give back some of what you get out - without our awesome registered users none of this would be possible! Plus, you get way more great stuff as a member! Lurk to lose, participate to WIN*!
* The joy of participation and being generally awesome constitutes winning
** Not an actual guarantee, but seriously, you probably won't regret it!
Serving the Subaru Community since May 18th, 1998!
PK lift install, not so bad!
Posted 03 June 2005 - 08:40 AM
From all the reading I did before PK's lift kit got here, I figured It might be tough for a novice, but do-able. Then when I unpacked it, I got pretty scared. Parts not really ID'd for crap, pretty skimpy instructions. But what the heck, had to go for it.
Yupper, lining things up in front is probably the toughest part. Untill ya get things going. Then it gets easier. And for what goes where, it does become self explanatory as you go, but ya got to stop and think.
I did indeed strip one hole and bolt. Had to drill and tap.
Rear was easier, but jeeze, some of those pieces do not go where the diagram shows. Period. Well, just in one spot. But since it's physically impossible for them to fit like the diagram, again, just had to stop and look and think. It became obvious.
And wow! What a difference! I love sitting up higher! Handles better too, but I suppose thats because I replaced the old worn out strutts and coil-overs with not used up ones.
Like where the shifter sits lower too.
Now just need my 15 inch rims from Shady, tires, Weber, (or figure out the FI swap, and I'm set.
Posted 03 June 2005 - 11:38 AM
Posted 03 June 2005 - 02:25 PM
Wewt another lifted subaru! Only thing tough about installing a BYB kit is if you have lots of rusty bolts to contend with!
Yup I'd bet that would be horrible. These high desert Eastern Oregon Soobs, lots of them have Zero rust. All three of mine, no rust at all. I was also fortunate that much engine work had been done before I bought it with a shot auto trans. So for both the tranny swap and the lift install, no grease or oil! She was clean underneath. Couldn't believe my good luck, rarely do I get to work on a clean car!
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users