daehttub2000 Posted January 30, 2006 Share Posted January 30, 2006 I have one grip about my bulletproof 1995 Legacy. The instrument panel control switch lights burned out early (apparently a common Subaru problem). I lost the excellent forum thread/posting about how to replace the hard-to-access switch lights. I’m not sure which Subie forum it was on but it was incredibly detailed. I can’t figure out how to access the 2 light bulbs inside the heater/ac/ventilation control unit. The entire unit is tethered by that @#* cable connected to the vent temperature control. Any helpful hints would be appreciated. The defrost/cruise/foglight button lights were simple enough. The total cost for all eight light bulbs are about $26. The dealer estimated a $200 cost to replace them. Note: Any aspiring would-be Subaru mechanics should disconnect the battery cable and wait 10 minutes before trying this at home (air bag). Thanks! Driving in the Dark Quote Link to comment Share on other sites More sharing options...
cookie Posted January 30, 2006 Share Posted January 30, 2006 1995 early???? Quote Link to comment Share on other sites More sharing options...
Handtool Posted January 30, 2006 Share Posted January 30, 2006 http://www.ultimatesubaru.org/forum/showthread.php?t=2498&page=1&pp=10&highlight=climate+control+backlight Quote Link to comment Share on other sites More sharing options...
daehttub2000 Posted January 31, 2006 Author Share Posted January 31, 2006 http://www.ultimatesubaru.org/forum/showthread.php?t=2498&page=1&pp=10&highlight=climate+control+backlight Handtool: Thanks for the awesomely fast response. 6-7 pages of the forum thread and great instructions! It's funny how big of a problem these lights are on the 95'ish Legacy. I should have done this a long time ago but I didn't find this message board until recently. You Rock. I can see the light at the end of the tunnel... Quote Link to comment Share on other sites More sharing options...
97OBW Posted January 31, 2006 Share Posted January 31, 2006 Driving in the Dark it was fairly easy to get to but then i finally unhooked everything except the heat/cool cable thing ...this thing is on a clip type of thing, so i tore the unimportant looking clip apart so the cable could come loose...DONT DO THIS unless u want no air temp control... i had to put the cable back in place with the torn up clip and started soldering it and random pieces of plastic to it so it would hold it while u move the cable for heat or cool. it works now though,, just a huge rump roast pile of melted stuff together on it! Quote Link to comment Share on other sites More sharing options...
Legacy777 Posted January 31, 2006 Share Posted January 31, 2006 The FAQ sticky had the link you wanted http://www.ultimatesubaru.org/forum/showthread.php?t=51554 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.