TomsSVX
-
Posts
100 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Store
Posts posted by TomsSVX
-
-
Just checked... not sure his will work for my 2.5 its a 2000
Tom
-
Yea same guy... i will take a look for the guy here
-
I am trying to upgrade the exhuast on my outback. I have been known to make some pretty cool exhaust systems including full headerback systems for other subies for years but for this car it will be easier and cheaper just to buy pre-made stuff. I found a couple obx products kicking around ebay but not totally sure they will fit the outback wag. The links are listed below. I want a new set of headers, not just a new y-pipe. I want a highflow cat set and a nice but not over the top cat-back. Its a daily driver not a race car so I like a little noise but not overwhelming at 80mph. Any tips?
Tom
http://www.ebay.com/itm/171003377145?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649
http://www.ebay.com/itm/181060676159?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649
-
There is a fuel pump relay under the dash by the ecm. There is also a fuel pump resistor under the rear deck lid... need to see where power is lost
Tom
-
YAY I like fire:banana:
:banana::banana:Tom
-
you don't... It is 11. It is the only suby pinion to use 11 teeth.
Tom
-
no
Its either 10 or 9
tom
-
So you used the XT center race, and the SVX balls and cage? is that correct? sounds too easy.
How has this setup held up to stress?
Cannot remember if I used the XT6 cage or not.
I thought it was too easy as well... Hasn't had any problems in past year (almost a year) it has been done. Worked out well. If you need the SVX inner CV cups let me know
Tom
-
Link... http://subaruxt.com/forum/viewtopic.php?f=1&t=2089&st=0&sk=t&sd=a&start=90
Its actually pretty simple when it comes down to it. Let me know if you have any questions
Tom
-
I have done it. I used a VLSD in a 4.44 XT6 swap. I will try to dig up the thread from the xt6 board.
Tom
-
Your not allowed to burn your car....
:(Tom
-
can we build a fire??
:grin:Tom
-
Looks like you guys had fun even though you put a car through the ice!
I'm jealous! Can you guys all come up to Maine this summer and I'll show you some trails!?!!?!?No more ice please:rolleyes:
I had a fun time... Yea I sunk my 215k mile forester... BUT it still runs fine. Stripped the interior out already and drove it home from the shop tonight... Might be able to get some more work done tomorrow... So far it looks like just the ECU kicked the can... We will see.
Tom
-
Leaving in 10 mins... See you all there!!
Tom
-
See you guys tomorrow at 1030 at the ranger's station!!!
:banana:Tom (now with more coolant than water:eek:
) -
two more days... No one else joining in on the fun?? Its gonne be icey!!! expecting 8* around here tonight and very chilly temps tomorrow too
Tom
-
DONE!! but the sol. C in the trans i put in is no good... Grrrr torque bind... Good for wheeling of SAT though!!!!
Tom
-
I'd be done right about now... If there were ATF anywhere to be found... Wonder where all that went.... MIKE!!!!
Tom
-
The Fonz will have a new tranny in it too:grin: 3.545 gears for better mileage (hopefully) and a 3.545 swapped 07 wrx rear diff for some sweet LSD action:grin:Stoked to try it out
Tom
-
shhhhwwwwwwweeeettttttttt
tom, rangers or tower? i have to meet a couple of peeps down at the rangers.. and grab a nice breakfast at the diner first
Was gonna meet at the ranger's station at 1030... we still good for thaT?
Tom
-
Buddy of mine is comming in his 04 wrx:banana:
Tom
-
Your just going to break it again
nipper
Meh... prob not:banana:
Tom
-
:grin::grin::lol::lol::lol::lol:
hehehe I still need a corner light for the Fonz ya know:eek:
Tom
-
as long as Neo and myself can keep from sinking our vehicles... it should be warm inside the dry cars:grin:
Tom
Exhaust options 00 Outback wag
in 1990 to Present Legacy, Impreza, Outback, Forester, Baja, WRX&WrxSTI, SVX
Posted
anything from anyone?
Tom