Jump to content
Ultimate Subaru Message Board

TomsSVX

Members
  • Posts

    100
  • Joined

  • Last visited

Everything posted by TomsSVX

  1. I am trying to upgrade the exhuast on my outback. I have been known to make some pretty cool exhaust systems including full headerback systems for other subies for years but for this car it will be easier and cheaper just to buy pre-made stuff. I found a couple obx products kicking around ebay but not totally sure they will fit the outback wag. The links are listed below. I want a new set of headers, not just a new y-pipe. I want a highflow cat set and a nice but not over the top cat-back. Its a daily driver not a race car so I like a little noise but not overwhelming at 80mph. Any tips? Tom http://www.ebay.com/itm/171003377145?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649 http://www.ebay.com/itm/181060676159?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649
  2. There is a fuel pump relay under the dash by the ecm. There is also a fuel pump resistor under the rear deck lid... need to see where power is lost Tom
  3. I don't know of anyone... If I wasn't so busy I would take a peek at it but I cannot. I just bought a 2000 2.5 in decent shape. Sorry I am not much help

  4. Hi, interested in your car for sale. Please call me at (609) 276 7279 and we can chat. Thanks

  5. you don't... It is 11. It is the only suby pinion to use 11 teeth. Tom
  6. Cannot remember if I used the XT6 cage or not. I thought it was too easy as well... Hasn't had any problems in past year (almost a year) it has been done. Worked out well. If you need the SVX inner CV cups let me know Tom
  7. Link... http://subaruxt.com/forum/viewtopic.php?f=1&t=2089&st=0&sk=t&sd=a&start=90 Its actually pretty simple when it comes down to it. Let me know if you have any questions Tom
  8. I have done it. I used a VLSD in a 4.44 XT6 swap. I will try to dig up the thread from the xt6 board. Tom
  9. No more ice please:rolleyes: I had a fun time... Yea I sunk my 215k mile forester... BUT it still runs fine. Stripped the interior out already and drove it home from the shop tonight... Might be able to get some more work done tomorrow... So far it looks like just the ECU kicked the can... We will see. Tom
  10. See you guys tomorrow at 1030 at the ranger's station!!!:banana: Tom (now with more coolant than water:eek:)
  11. two more days... No one else joining in on the fun?? Its gonne be icey!!! expecting 8* around here tonight and very chilly temps tomorrow too Tom
  12. DONE!! but the sol. C in the trans i put in is no good... Grrrr torque bind... Good for wheeling of SAT though!!!! Tom
  13. I'd be done right about now... If there were ATF anywhere to be found... Wonder where all that went.... MIKE!!!! Tom
  14. The Fonz will have a new tranny in it too:grin: 3.545 gears for better mileage (hopefully) and a 3.545 swapped 07 wrx rear diff for some sweet LSD action:grin:Stoked to try it out Tom
×
×
  • Create New...