hi

i've got on ebay a camber kit adjustment bolts , instaled them on my rear wheels as i've got a 18' set of rims but i'm unable to get a proper negative camber, positve i can really see the diference whwn turning the bolts, but negative doesn't seems to go to much over the standard position....any suggestions? is there anything related to the struts mounting??

thanks a lot1

You may need to slot (cut a larger hole) in the strut where the camber bolt goes. This will give you a little more room to move the strut to give you the negative camber you want.

 

I wouldn't cut too large a hole, just do a little bit at a time.

As Josh said it's really about making the holes bigger in either the hub or the strut to allow for the hub to move. I think on our rally car we actually ground the hub out to allow the adjustment on any struts we installed.

 

Keith