November 20, 201312 yr 93 legacy 2.2 wagon cruise control will engage and power the vehicle forward, but much lower than the set speed, and then only on flat or descending inclines. If I encounter a slight uphill, then it slows. Example: I set it at 45 MPH on a slight downhill, and it maintained it, but when I encountered an uphill portion of the road it slowed to 30 and stayed at thirty until the next downhill. At higher speeds (65 MPH) it won't maintain at all but will fall back to 55-60 even on flats or slight downhills. Thoughts? On a slightly unrelated note, the speedometer cable has recently(past 2 weeks) become noisy. Is it possible to lube, or should I just replace? The cruise issue is a year old, so I wouldn't think there's a correlation between the two, but...
November 20, 201312 yr the cruise issue sounds like it might be vacuum related - when was the last time you checked/replaced vacuum lines? old, hard, brittle vacuum lines wont hold as good a vacuum as new soft/supple ones will.
November 21, 201312 yr Sounds like its losing vacuum or the actuator servo isn't holding vacuum. Did you install the cruise? Does it use a vacuum pump or engine vacuum for the source?
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now