I just got my hub grappler kit, I'm about to do a set of rear wheel bearings on a 97 impreza.

Of course they only list the front bearing in the book the give you Subaru rear wheel bearings are really the only reason I bought this kit.

 

I figure the same method for the front will probably work for the back as well so I'm crossing my fingers there.

 

Anyone on the board got one of these? Have anyone used it on a rear bearing on a subaru? I've got a couple really rusty rear hub Assembly's off a 97 legacy I can ply around with to get the idea, I'm just hoping it will work for what I just bought it for.

Never mind, I just pulled apart a rear hub assembly off of a 95 legacy I had laying around. Didnt even hesitate to pull apart with my dewalt 1/2" impact. It is the same method for pulling a front bearing, but you have to swap 311882 for 311883 to get the bearing out